Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > CondenserREMOVAL1. Using the refrigerant recovery system, discharge refrigerant. Refrigerant Recovery Procedure > PROCEDURE">2. Remove the air intake duct. Air Intake Duct > REMOVAL">3. Remove the clip, and remove the bracket - gr ...
Inspection
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingINSPECTION1. Moving the rear tire up and down by hand, check there is no looseness in bearing, and check the wheel rotates smoothly.CAUTION:If there is unsmooth sliding operation or abnormal noise in the bearing, replace the rear hub unit bearing.2. Inspe ...
Installation
CONTROL SYSTEMS > Select LeverINSTALLATION1. Set the select lever assembly to the vehicle body.2. Tighten the four mounting bolts to attach the select lever assembly to the vehicle body.Tightening torque:18 N·m (1.8 kgf-m, 13.3 ft-lb)3. Connect the harness connector.4. Install the harness ...