Subaru Crosstrek Service Manual: Disassembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Drive Gear
DISASSEMBLY
1. Remove the snap ring.
2. Remove the ball bearing.
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Drive GearREMOVAL1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the ...
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Drive GearINSPECTION1. Ball bearingReplace the bearings in the following cases.• In case of broken or rusty bearings• In case of wor ...
Other materials:
Dtc p2751 intermediate shaft speed sensor "c" circuit no signal
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2751 INTERMEDIATE SHAFT SPEED SENSOR "C" CIRCUIT NO SIGNALDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Shifting shock is felt.• Acceler ...
Remote transmitter program (models without "keyless access with push-button
start system")
New transmitters can be programmed to
the remote engine start system in the
event that a transmitter is lost, stolen,
damaged or additional transmitters are
desired (the system will accept up to eight
transmitters). New remote engine start
transmitters can be programmed accord-ing to the follo ...
Windshield wiper blade assembly
1. Raise the wiper arm off the windshield.
1) Stopper
2. Remove the wiper blade assembly by
holding its pivot area and pushing it in the
direction shown by the arrow while depressing
the wiper blade stopper.
3. Install the wiper blade assembly to the
wiper arm. Make sure that it locks i ...
