PARKING BRAKE > General Description
CAUTION
• Wear appropriate work clothing, including a helmet, protective goggles and protective shoes when performing any work.
• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, installation, disassembly and replacement.
• Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.
• Use SUBARU genuine grease etc. or equivalent. Do not mix grease etc. of different grades or manufacturers.
• Be sure to tighten fasteners including bolts and nuts to the specified torque.
• Place shop jacks or rigid racks at the specified points.
• Make sure grease does not come into contact with the parking shoes.
Specification16
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code16Detected when ignition switch is turned to OFF or malfunction related to the ignition switch occurs.TROUBLE SYMPTOM:Cruise control cannot be set.WIRING DIAGRAM:Cruise control system Cruise Control System > WIRING DIA ...
Removal
SECURITY AND LOCKS > Front Door Latch and Door Lock Actuator AssemblyREMOVAL1. Raise the glass assembly - front door to the top position.2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">3. Remove the trim panel - front door. Door T ...
Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Driven GearASSEMBLY1. Using the ST, install the taper roller bearing (transfer case side).CAUTION:Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).NOTE:Be careful when handling, because the outer race and inner race of th ...