Subaru Crosstrek Service Manual: Inspection
LIGHTING SYSTEM > Luggage Room Light
INSPECTION
1. LUGGAGE ROOM LIGHT BULB
1. Visually check the bulb for blow out.
2. Check the bulb specification. General Description > SPECIFICATION">
3. Replace the bulb if it is found defective.
2. LUGGAGE ROOM LIGHT SWITCH
1. Check the resistance between switch terminals.
Preparation tool:
Circuit tester
Terminal No. | Inspection conditions | Specification | Connection diagram |
1 — 2 | Switch OFF | 1 M? or more |
Switch ON
Less than 1 ?
2. Replace the light assembly - luggage room if the inspection result is not within the standard value.
Removal
LIGHTING SYSTEM > Luggage Room LightREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - luggage room.CAUTION:When using a flat tip screwdriver, apply p ...
Other materials:
Roof antenna (for Rod type)
CAUTION
Be sure to remove the antenna
rod before entering garages,
parking towers and other locations
with low ceilings.
Remove the antenna rod before
washing your car at a car wash. If
the antenna rod is left attached, it
may scratch the roof.
When reinstalling the removed
ant ...
Handling of radar sensors
Radar sensors
The radar sensors, one on each side of
the vehicle, are mounted inside the rear
bumper.
CAUTION
To ensure correct operation of the
BSD/RCTA, observe the following
precautions.
Always keep the bumper surface
near the radar sensors clean
Do not affix any stickers o ...
Models with "keyless access with push-button start system"
NOTE
For more details, refer to the Owner's
Manual supplement for the remote
engine start system.
Access key
Lock button
An access key can be used as the remote
engine start transmitter. Operate the lock
button to start or stop the engine as
follows.
Before starting the engine
Befo ...
