Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Specification

LIGHTING SYSTEM > Auto Headlight Beam Leveler System

SPECIFICATION

1. AUTO HEADLIGHT BEAM LEVELER CM

Refer to “Control Module I/O Signal” of “AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS)” section. Control Module I/O Signal > ELECTRICAL SPECIFICATION">

Wiring diagram
LIGHTING SYSTEM > Auto Headlight Beam Leveler SystemWIRING DIAGRAMRefer to “Headlight Beam Leveler System” in the wiring diagram. Headlight Beam Leveler System > WIRING DIAGRAM" ...

Back-up light bulb
...

Other materials:

Replacing bulbs
WARNING Lighting bulbs in your Subaru Ascent can become extremely hot during operation. Always switch off the lights and allow sufficient time for the bulbs to cool before attempting replacement. Failure to do so may result in burns or injury. CAUTION Always replace bulbs in your Subaru Ascen ...

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Speed SensorINSTALLATIONCAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary speed sensor. If adhesion occurs, replace with a new part.• After installing the secondary speed sensor, adjust t ...

Dtc p0117 engine coolant temperature sensor 1 circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0117 ENGINE COOLANT TEMPERATURE SENSOR 1 CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Hard to start• Improper idling• Poor driving performanceCAUTION: ...

© 2016-2026 Copyright www.sucross.com