Subaru Crosstrek Service Manual: Wiring diagram
LIGHTING SYSTEM > Auto Headlight Beam Leveler System
WIRING DIAGRAM
Refer to “Headlight Beam Leveler System” in the wiring diagram. Headlight Beam Leveler System > WIRING DIAGRAM">
Note
LIGHTING SYSTEM > Auto Headlight Beam Leveler SystemNOTEFor operation procedures of each component of the auto headlight beam leveler system, refer to the respective section.• Auto headlight ...
Specification
LIGHTING SYSTEM > Auto Headlight Beam Leveler SystemSPECIFICATION1. AUTO HEADLIGHT BEAM LEVELER CMRefer to “Control Module I/O Signal” of “AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAG ...
Other materials:
Removal
REAR SUSPENSION > Front Lateral LinkREMOVAL1. Lift up the vehicle, and then remove the rear wheels.2. Remove the bolts and nuts, and then remove the trailing link.3. Remove the lateral link assembly - front.(1) Remove the snap pin (a) and nut (b).(2) Remove the ball joint from the housing assembl ...
Dtc b2a00 vin reading
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A00 VIN READINGDiagnosis start condition:When ignition switch is ON.DTC detecting condition:When ignition switch is ON, VIN information (CAN) sent from ECM cannot be read.Trouble symptom:• Telemat ...
Switches and harness
Inspection
Blind Spot Detection/Rear Cross Traffic Alert > Switches and HarnessINSPECTIONBSD/RCTA OFF switch1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard1 — 2Switch OFF1 M? or moreSwitch ONLess than 1 ?2. Apply ba ...
