Subaru Crosstrek Service Manual: Installation
LIGHTING SYSTEM > Day Time Running Resistor
INSTALLATION
Install each part in the reverse order of removal.
Tightening torque:
Resistor assembly - daytime running light: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
Removal
LIGHTING SYSTEM > Day Time Running ResistorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle.3. Remove the screw and clips, and turn over the front side of t ...
Door switch
...
Other materials:
Interruption screen
Warning information (display example)
Useful messages, such as reminder information,
vehicle information, warning
information, etc. may interrupt the current
screen and appear on the display accompanied
by a beep. Take proper action
according to the message.
The warning screen will retu ...
Component
INTAKE (INDUCTION)(H4DO) > General DescriptionCOMPONENT(1)Air intake duct(8)Air cleaner case (rear)Tightening torque: N·m (kgf-m, ft-lb)(2)Clip(9)ClipT1:1 (0.1, 0.7)(3)Cushion(10)Mass air flow and intake air temperature sensorT2:3 (0.3, 2.2)(4)Air cleaner case (front)(11)ClampT3:6 (0.6, 4. ...
Engine wiring harness and transmission cord Location
WIRING SYSTEM > Engine Wiring Harness and Transmission CordLOCATIONConnectorConnecting toNo.PoleColorAreaNo.DescriptionE254BlackA-3B21Bulkhead wiring harnessE316BrownA-3B22E42BlueB-4 Purge control solenoid valveE52Dark grayB-2 Fuel injector No. 1E62Dark grayA-2 Fuel injector No. 3E82BlackB-2 Engi ...
