Subaru Crosstrek Service Manual: Spot map light

Installation

LIGHTING SYSTEM > Side Turn Signal Light AssemblyINSTALLATIONInstall each part in the reverse order of removal. ...

Inspection

LIGHTING SYSTEM > Spot Map LightINSPECTION1. SPOT MAP LIGHT BULB1. Visually check the bulb for blow out.2. Check the bulb specification. General Description > SPECIFICATION">3. Replace ...

Other materials:

Removal
LIGHTING SYSTEM > Rear Combination Light AssemblyREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear ...

Installation
CLUTCH SYSTEM > Clutch PedalINSTALLATION1. Install in the reverse order of removal.CAUTION:Always use a new clevis pin.Tightening torque:Clutch pedal18 N·m (1.8 kgf-m, 13.3 ft-lb)Knee airbag module7.5 N·m (0.76 kgf-m, 5.5 ft-lb)Air intake boot3 N·m (0.3 kgf-m, 2.2 ft-lb)2. Ad ...

Dtc u0155 lost communication with instrument panel cluster (ipc) control module
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0155 LOST COMMUNICATION WITH INSTRUMENT PANEL CLUSTER (IPC) CONTROL MODULEDetected when CAN data from combination meter does not arrive.NOTE:Perform the diagnosis for LAN syst ...