Subaru Crosstrek Service Manual: Specification
LIGHTING SYSTEM > General Description
SPECIFICATION
No. | Description | Capacity and wattage | Type | |
(1) | Headlight | Low beam (halogen type) | 12 V — 55 W | H11 |
Low beam (HID type) | 12 V — 35 W | D2R | ||
High beam | 12 V — 60 W | HB3 | ||
Front turn signal light | 12 V — 21 W | WY21W | ||
Parking light | 12 V — 5 W | W5W | ||
Side marker light | 12 V — 5 W | W5W | ||
(2) | Front fog light | Model without SRF | 12 V — 24 W | PSX24W |
Model with SRF | 12 V — 55 W | H11 | ||
(3) | Side turn signal light | 12 V — 1.1 W (LED) | * | |
4) | Rear combination light | Tail/stop light | 12 V — 5 / 21 W | W21/5W |
Back-up light | 12 V — 16 W | W16W | ||
Turn signal light | 12 V — 21 W | WY21W | ||
Side marker light | 12 V — 5 W | W5W | ||
(5) | License plate light | 12 V — 5 W | W5W | |
(6) | High-mounted stop light | 12 V — 2.1 W (LED) | * | |
(7) | Luggage room light | 12 V — 5 W | W5W | |
(8) | Room light | 12 V — 8 W | — | |
(9) | Spot map light | 12 V — 8 W | — | |
(10) | Glove box light | 12 V — 1.4 W | * | |
*: Non-disassembly type
Caution
LIGHTING SYSTEM > General DescriptionCAUTION• Before disassembling or reassembling parts, always disconnect the battery ground cable from battery. When replacing the audio, control module and ...
Preparation tool
LIGHTING SYSTEM > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for el ...
Other materials:
Child restraint systems
Infants and small children should always
be placed in an infant or child restraint
system in the rear seat while riding in the
vehicle. You should use an infant or child
restraint system that meets Federal Motor
Vehicle Safety Standards or Canada
Motor Vehicle Safety Standards, is compatib ...
Treadwear
The treadwear grade is a comparative
rating based on the wear rate of
the tire when tested under controlled
conditions on a specified
government test course.
For example, a tire graded 150
would wear one and one-half (1-
1/2) times as well on the government
course as a tire graded 100.
...
Assembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Drive Pinion Shaft AssemblyASSEMBLY1. Install the plug to drive pinion retainer.NOTE:• Use new O-rings.• Apply CVTF to the O-rings.Tightening torque:22 N·m (2.2 kgf-m, 16.2 ft-lb)2. Using the ST, install the oil seal to drive pinion r ...
