Subaru Crosstrek Service Manual: Installation
LIGHTING SYSTEM > High-mounted Stop Light
INSTALLATION
Install each part in the reverse order of removal.
Tightening torque:
Light assembly - high-mounted: 4.5 N·m (0.46 kgf-m, 3.3 ft-lb)
Removal
LIGHTING SYSTEM > High-mounted Stop LightREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate UPR. Rear Gate Trim > REMOVAL& ...
Other materials:
Check power supply and ground line of engine control module (ecm)
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostics for Engine Starting FailureCHECK POWER SUPPLY AND GROUND LINE OF ENGINE CONTROL MODULE (ECM)CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION">, and Inspection Mode Inspection Mode > ...
General diagnostic table Inspection
CONTROL SYSTEMS > General Diagnostic TableINSPECTIONSymptomsPossible causeCorrective actionSelect leverStarter does not run.Adjust the select cable and inhibitor switch, or inspect the circuit.Back-up light does not illuminate.Adjust the select cable and inhibitor switch, or inspect the circuit.A ...
Inspection
LIGHTING SYSTEM > Spot Map LightINSPECTION1. SPOT MAP LIGHT BULB1. Visually check the bulb for blow out.2. Check the bulb specification. General Description > SPECIFICATION">3. Replace the bulb if it is found defective.2. SPOT MAP LIGHT SWITCH1. Check the resistance between switch ter ...
