Subaru Crosstrek Service Manual: Ignition switch illumination

Installation

LIGHTING SYSTEM > High-mounted Stop LightINSTALLATIONInstall each part in the reverse order of removal.Tightening torque:Light assembly - high-mounted: 4.5 N·m (0.46 kgf-m, 3.3 ft-lb) ...

Inspection

LIGHTING SYSTEM > Ignition Switch IlluminationINSPECTIONSTEPCHECKYESNO1.CHECK THE IGNITION SWITCH ILLUMINATION.Make sure the ignition switch illumination illuminates when driver’s side door i ...

Other materials:

Removal
SECURITY AND LOCKS > Body Integrated UnitREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from battery and wait ...

Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyADJUSTMENTSelection of main shaft rear plate:Measure the protrusion amount (A) of ball bearing from transmission main case surface, and select a suitable plate in the following table.NOTE:Before measuring, tap the end of main shaft wi ...

Disassembly
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Drain SeparatorDISASSEMBLY1. Disconnect the drain tube (A) from the leak check valve assembly.NOTE:Disconnect the quick connector as shown in the figure.2. Lift up the claw (B) of the drain separator and slide the drain separator in the dir ...