Subaru Crosstrek Service Manual: Inspection
LIGHTING SYSTEM > Ignition Switch Illumination
INSPECTION
| STEP | CHECK | YES | NO |
1.CHECK THE IGNITION SWITCH ILLUMINATION.
Make sure the ignition switch illumination illuminates when driver’s side door is open.
Does the ignition switch illumination illuminate?
Ignition switch illumination is normal.
Ignition Switch Illumination > INSPECTION">Go to Step 2.
2.CHECK THE IGNITION SWITCH ILLUMINATION.
Make sure the ignition switch illumination blinks when the ignition switch is turned to ON.
Does the ignition switch illumination blink?
Check the function setting of body integrated unit. Basic Diagnostic Procedure">
Check the ignition switch illumination circuit. Keyless Entry System > INSPECTION">
Removal
LIGHTING SYSTEM > Ignition Switch IlluminationREMOVALNOTE:The ignition switch illumination is integrated into the immobilizer antenna assembly.1. Disconnect the ground cable from battery. NOTE&quo ...
Other materials:
Dtc b19f3 short in front p/t 2 rh (to +b)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B19F3 SHORT IN FRONT P/T 2 RH (TO +B)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Lap seat belt pretensioner (RH) circuit is shorted to power supply.• Lap seat belt pretensioner ...
Dtc p2270 o2 sensor signal biased/stuck lean bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2270 O2 SENSOR SIGNAL BIASED/STUCK LEAN BANK 1 SENSOR 2DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Me ...
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Oil PumpREMOVAL1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">2. Remove the torque converter assembly. Torque Converter Assembly > REMOVAL">3. Remove the oil pump chain cover. Oi ...
