LIGHTING SYSTEM > Combination Switch (Light)
INSPECTION
Measure the resistance between connector terminals. If it is not within the standard value, replace the switch assembly - combination turn dimmer.
Preparation tool:
Circuit tester

1. LIGHTING SWITCH
Terminal No. | Inspection conditions | Standard |
18 — 12 19 — 12 20 — 12 | Switch OFF | 1 M? or more |
19 — 12 | Switch AUTO | Less than 1 ? |
18 — 12 | Switch 1 (TAIL/PARKING) | Less than 1 ? |
18 — 12 20 — 12 | Switch 2 (HEAD) | Less than 1 ? |
2. DIMMER & PASSING SWITCH
Terminal No. | Inspection conditions | Standard |
11 — 12 17 — 12 | Switch PASS | Less than 1 ? |
11 — 12 | Switch UP | Less than 1 ? |
3. TURN SIGNAL SWITCH
Terminal No. | Inspection conditions | Standard |
13 — 12 | Switch TURN (RH) | Less than 1 ? |
15 — 12 | Switch TURN (LH) | Less than 1 ? |
4. FRONT FOG LIGHT SWITCH
Terminal No. | Inspection conditions | Standard |
4 — 3 | Switch OFF | 1 M? or more |
Switch ON | Less than 1 ? |
RemovalClear memory mode Operation
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Clear Memory ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» displa ...
Dtc p015a a/f / o2 sensor delayed response - rich to lean bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P015A A/F / O2 SENSOR DELAYED RESPONSE - RICH TO LEAN BANK 1 SENSOR 1NOTE:For the diagnostic procedure, refer to DTC P014C. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P014C A/F / O2 SENS ...
Specification
DRIVE SHAFT SYSTEM > General DescriptionSPECIFICATION1. PROPELLER SHAFTPropeller shaft typeEDJFront propeller shaft joint-to-joint length: L1CVT675.5 mm (26.59 in)MT735.5 mm (28.96 in)Rear propeller shaft joint-to-joint length: L2723 mm (28.46 in)Outer diameter of tube:D163.5 mm (2.50 in)D257.5 m ...