Subaru Crosstrek Service Manual: Clearance light and illumination light system

Note

LIGHTING SYSTEM > Back-up Light SystemNOTEFor operation procedures of each component of the back-up light system, refer to the respective section.• Rear combination light assembly: Rear Comb ...

Inspection

LIGHTING SYSTEM > Clearance Light and Illumination Light SystemINSPECTION1. CHECK LIGHTING SWITCHRefer to the “INSPECTION” of the “Combination Switch (Light)”. Combination ...

Other materials:

Control unit Note
EyeSight > Control UnitNOTESystem control of the EyeSight is performed by each module. For procedure, refer to the following sections.• Engine control module (ECM): Engine Control Module (ECM)">• Transmission control module (TCM): Transmission Control Module (TCM)">& ...

Refrigerant leak check Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Refrigerant Leak CheckINSPECTION1. Attach the manifold gauge set.Preparation tool:Manifold gauge set(1) Check that all valves are fully closed.(2) Install the low/high pressure hoses to the service ports on the low/high pressure sides of the vehicle resp ...

To increase the speed (by the "RES/ SET" switch)
Press the "RES/SET" switch to the "RES" side and hold it until the vehicle reaches the desired speed. Then, release the switch. The vehicle speed at that moment will be memorized and treated as the new set speed. U.S.-spec. models When the difference between the actual vehicle speed and ...