Subaru Crosstrek Service Manual: Inspection
LIGHTING SYSTEM > Clearance Light and Illumination Light System
INSPECTION
1. CHECK LIGHTING SWITCH
Refer to the “INSPECTION” of the “Combination Switch (Light)”. Combination Switch (Light) > INSPECTION">
Wiring diagram
LIGHTING SYSTEM > Clearance Light and Illumination Light SystemWIRING DIAGRAMRefer to “Clearance Light and Illumination Light System” in the wiring diagram. Clearance Light and Illumin ...
Other materials:
Dtc p2195 a/f /o2 sensor signal biased/stuck lean bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2195 A/F /O2 SENSOR SIGNAL BIASED/STUCK LEAN BANK 1 SENSOR 1DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Cle ...
Installation
FRONT SUSPENSION > Front StrutINSTALLATION1. Install the strut mount - front at the upper side of the strut to the body, and tighten it with new flange nuts.Tightening torque:20 N·m (2.04 kgf-m, 14.8 ft-lb)2. Align alignment marks on the camber adjusting bolt and strut.Using new self-locki ...
Disassembly
CONTROL SYSTEMS > Select LeverDISASSEMBLY1. GRIP ASSY1. Remove the button assembly_AT.(A)Claw2. Remove the rod COMPL.2. AT SELECT LEVER ASSEMBLY1. Remove the spacer plate.2. Remove the gasket.3. Insert a flat tip screwdriver with a thin tip under the connector and disconnect the harness connector ...
