Subaru Crosstrek Service Manual: Wiring diagram
LIGHTING SYSTEM > Clearance Light and Illumination Light System
WIRING DIAGRAM
Refer to “Clearance Light and Illumination Light System” in the wiring diagram. Clearance Light and Illumination Light System > WIRING DIAGRAM">
Inspection
LIGHTING SYSTEM > Clearance Light and Illumination Light SystemINSPECTION1. CHECK LIGHTING SWITCHRefer to the “INSPECTION” of the “Combination Switch (Light)”. Combination ...
Note
LIGHTING SYSTEM > Clearance Light and Illumination Light SystemNOTEFor operation procedures of each component of the clearance light & illumination light system, refer to the respective section ...
Other materials:
Adjustment
BRAKE > Stop Light SwitchADJUSTMENT1. BULB TYPECAUTION:• Turn the stop light switch clockwise when installing so that it can return backward by approximately 1 mm (0.04 in) and clearance is automatically adjusted.• If it is hard to turn the switch, reduce the switch pushing force and ...
Top display setting
1. Perform the preparation steps according
to "Preparation for screen settings"
2. Operate the "
"
or "
" switch to
select the "Top Display" item. Then push
the
button.
3. Push the
button once more.
4. Select an item by operating the "
" or
"
" switc ...
Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR PipeINSTALLATION1. Temporarily install the EGR pipe to the intake manifold and water pipe assembly, and tighten the EGR pipe in numerical order as shown in the figure.NOTE:Use a new gasket.Tightening torque:6.4 N·m (0.7 kgf-m, 4. ...
