Subaru Crosstrek Service Manual: Installation

1. Install the reduction driven gear assembly and spacer oil.

Tightening torque:

17 N·m (1.7 kgf-m, 12.5 ft-lb)

2. Select the transfer drive gear shim. Reduction Drive Gear > ADJUSTMENT">

3. Install the parking pawl. Parking Pawl > INSTALLATION">

4. Attach the selected transfer drive gear shim to extension case with vaseline.

5. Install the transfer driven gear assembly. Transfer Driven Gear > INSTALLATION">

6. Install the transfer clutch assembly. Transfer Clutch > INSTALLATION">

7. Install the extension case. Extension Case > INSTALLATION">

8. Install the transmission assembly to the vehicle. Automatic Transmission Assembly > INSTALLATION">

Inspection

Reverse brake assembly

Other materials:

Climate control panel, audio panel, instrument panel, console panel, and switches
Use a soft, damp cloth to clean the climate control panel, audio equipment, instrument panel, center console, combination meter panel, and switches. CAUTION Do not use organic solvents such as paint thinners or fuel, or strong cleaning agents that contain those solvents. Doing so cou ...

Wheel bearing Inspection
PERIODIC MAINTENANCE SERVICES > Wheel BearingINSPECTION1. FRONT WHEEL BEARINGNOTE:Inspect the condition of front wheel bearing grease.1. Jack-up the front side of vehicle.2. While holding the front wheel by hand, swing it in and out to check bearing free play.3. Loosen the wheel nuts, and remove ...

Locking and unlocking from the outside
NOTE If you unlock the driver's door with a key (including a mechanical key) and open the door while the alarm system is armed, the alarm system is triggered and the vehicle's horn sounds. In this case, perform any of the following operations: Models with "keyless access with push-button st ...