Subaru Crosstrek Service Manual: Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reduction Driven Gear
INSPECTION
• Check the ball bearing for smooth rotation.
• Check the ball bearing for excessive looseness.
• Make sure each gear is not broken or damaged.
Disassembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reduction Driven GearDISASSEMBLY1. Flatten the tab of the lock nut.2. Using the ST, counter the rotation of the reduction driven gear assembly, and remov ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reduction Driven GearINSTALLATION1. Install the reduction driven gear assembly and spacer oil.Tightening torque:17 N·m (1.7 kgf-m, 12.5 ft-lb)2. S ...
Other materials:
Remote start safety features
For safety and security reasons, the
remote engine start system will prevent
starting (or stop the engine if running) and
sound the horn twice if any of the following
conditions is detected. In addition, the fob
will flash and beep 3 times.
The brake pedal is depressed
A key is in the ign ...
Dtc p0973 shift solenoid "a" control circuit low
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0973 SHIFT SOLENOID "A" CONTROL CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:Gear is not changed. (No up-shift)CAUTION:Use the check board ...
Dtc b2329 rear radar axis alignment incomplete
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2329 REAR RADAR AXIS ALIGNMENT INCOMPLETEDTC DETECTING CONDITION:Axis adjustment of the radar sensor has failed.(Forced termination of the Subaru Select Monitor, improper loca ...
