Subaru Crosstrek Service Manual: Dtc c0049 cruise controller abnormal

DTC detecting condition:

Faulty signal is received from the stereo camera.

Trouble symptom:

• VDC may not operate.

• EyeSight does not operate.

1.CHECK LAN SYSTEM.

Perform the diagnosis for LAN system. Basic Diagnostic Procedure">

Is there any fault in LAN system?

Perform the diagnosis according to DTC for LAN system. List of Diagnostic Trouble Code (DTC)">

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0049 CRUISE CONTROLLER ABNORMAL">Go to Step 2.

2.CHECK POOR CONTACT OF CONNECTORS.

Is there poor contact of the stereo camera connector?

Repair the connector.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0049 CRUISE CONTROLLER ABNORMAL">Go to Step 3.

3.CHECK STEREO CAMERA.

Perform the diagnosis for the EyeSight system. Basic Diagnostic Procedure">

Is the check result OK?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0049 CRUISE CONTROLLER ABNORMAL">Go to Step 4.

Perform the diagnosis according to DTC. Diagnostic Procedure with Diagnostic Trouble Code (DTC)">

4.CHECK VDCCM&H/U.

1) Connect all connectors.

2) Perform the Clear Memory Mode. Clear Memory Mode">

3) Perform the Inspection Mode. Inspection Mode">

4) Read the DTC. Read Diagnostic Trouble Code (DTC)">

Is the same DTC displayed?

Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)">

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0049 CRUISE CONTROLLER ABNORMAL">Go to Step 5.

5.CHECK DETECTION OF OTHER DTCS FOR VDC.

Read Diagnostic Trouble Code (DTC)">

Is any other DTC displayed?

Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">

Currently, it is normal. There may have been a temporary poor contact in the harness and connector or a temporary noise interference.

Dtc c0046 body integrated module communication circuit

Dtc c0056 g sensor abnormal

Other materials:

Seatbelt maintenance
To clean the seatbelts, use a mild soap and lukewarm water. Never bleach or dye the belts because this could seriously affect their strength. Inspect the seatbelts and attachments including the webbing and all hardware periodically for cracks, cuts, gashes, tears, damage, loose bolts or wor ...

Dtc b28b8 eyesight steering switch 1
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B28B8 EyeSight STEERING SWITCH 1Detected when EyeSight steering switch is not installed or has malfunction, or when the harness is faulty or open-circuited or in stuck ON condition.DTC detecting condition:• ...

Air cleaner element
WARNING Never operate the engine of your Subaru Ascent without the air cleaner element installed. This component not only filters incoming air but also acts as a safety barrier in case of engine backfire. Without it, flames could escape and cause serious burns or injury. CAUTION When replac ...