Subaru Crosstrek Service Manual: Disassembly

Subaru Crosstrek Service Manual / Continuously variable transmission(tr580) / Reduction driven gear / Disassembly

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reduction Driven Gear

DISASSEMBLY

1. Flatten the tab of the lock nut.

2. Using the ST, counter the rotation of the reduction driven gear assembly, and remove the lock nut.

ST1 18355AA000

PULLEY WRENCH

ST2 18334AA000

PIN SET

ST3 499987003

SOCKET WRENCH (35)

3. Remove the ball bearing using ST.

ST1 499757002

INSTALLER

ST2 498077300

REMOVER

4. Using the ST, remove the parking gear and transfer drive gear.

ST 899864100

REMOVER

5. Remove the collar.

NOTE:

When collar has been removed, do not reuse the reduction driven gear and/or shaft, and replace it with reduction driven gear COMPL.

Assembly

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reduction Driven GearASSEMBLY1. Using the ST, attach the collar.NOTE:• Attach the collar in the correct direction.• Use a new reduction drive ...

Inspection

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reduction Driven GearINSPECTION• Check the ball bearing for smooth rotation.• Check the ball bearing for excessive looseness.• Make sur ...

Other materials:

Dtc b27a1 driver side external antenna open
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B27A1 DRIVER SIDE EXTERNAL ANTENNA OPENDTC detecting condition:When open circuit occurs in the harness between keyless access CM and driver’s side front door outer handle. ...

Adjustment
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer ClutchADJUSTMENT1. Install the transfer clutch assembly to the extension case with the transfer driven gear shims and thrust bearings removed.2. Install the thrust bearing to the transfer driven gear.NOTE:Make sure to install in the right direc ...

Removal
FRONT SUSPENSION > Front Ball JointREMOVAL1. Lift up the vehicle, and then remove the front wheels.2. Remove the under cover - front. Front Under Cover > REMOVAL">3. Remove the clamp - stabilizer bushing on the left and right sides.4. Remove the ball joint assembly.(1) Pull out the co ...