Subaru Crosstrek Service Manual: Removal
FRONT SUSPENSION > Front Ball Joint
REMOVAL
1. Lift up the vehicle, and then remove the front wheels.
2. Remove the under cover - front. Front Under Cover > REMOVAL">
3. Remove the clamp - stabilizer bushing on the left and right sides.
4. Remove the ball joint assembly.
(1) Pull out the cotter pin (a), and remove the castle nut (b).
(2) Lower the front arm assembly, and remove the ball stud.
(3) Remove the bolt from the housing assembly - front axle.
(4) Extract the ball joint assembly from the housing assembly - front axle.
Inspection
FRONT SUSPENSION > Front Ball JointINSPECTION1. Check that there is no looseness by moving the upper and lower portions of front tire in an axial direction with the brake pedal depressed.• Lo ...
Installation
FRONT SUSPENSION > Front Ball JointINSTALLATION1. Install the ball joint assembly to the housing assembly - front axle.CAUTION:• Do not apply grease to the tapered portion of ball stud.• ...
Other materials:
Dtc b2784 antenna circuit (push engine switch)
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2784 ANTENNA CIRCUIT (PUSH ENGINE SWITCH)DTC detecting condition:When open or short circuit occurs in the antenna coil.Trouble symptom:The keyless access function may not be op ...
Dtc c1252 wheel speed sensor signal of one of the wheels
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1252 WHEEL SPEED SENSOR SIGNAL OF ONE OF THE WHEELSDTC detecting condition:• Defective ABS wheel speed sensor signal (noise, irregular signal, etc.)• Defective magnetic encoder&b ...
Removal
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingREMOVAL1. Lift up the vehicle, and then remove the rear wheels.2. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lift the crimped section of axle nut.(2) Remove the axle n ...
