Subaru Crosstrek Service Manual: Inspection
LIGHTING SYSTEM > Day Time Running Resistor
INSPECTION
1. Measure the resistance between connector terminals.
Preparation tool:
Circuit tester
Terminal No. | Inspection conditions | Specification | Connection diagram |
1 — 2 | Always | 1.13±0.05 ? |
2. Replace the resistor assembly - daytime running light if the inspection result is not within the standard.
Removal
LIGHTING SYSTEM > Day Time Running ResistorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle.3. Remove the screw and clips, and turn over the front side of t ...
Other materials:
Rear window wiper blade rubber
1. Pull out the end of the blade rubber
assembly to unlock it from the plastic
support.
2. Pull the blade rubber assembly out of
the plastic support.
1) Metal spines
3. If the new blade rubber is not provided
with two metal spines, remove the metal
spines from the old blade rubbe ...
Dtc u0101 lost communication with tcm
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0101 LOST COMMUNICATION WITH TCMDetected when CAN data from TCM does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...
Subaru select monitor Operation
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Subaru Select MonitorOPERATIONFor detailed operation procedures, refer to “Application help”.NOTE:When initialization communication using Select Monitor is impossible, perform diagnosis according to “Diagnostic Procedure Used When Abnormal ...
