Subaru Crosstrek Service Manual: Subaru select monitor Operation
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Subaru Select Monitor
OPERATION
For detailed operation procedures, refer to “Application help”.
NOTE:
When initialization communication using Select Monitor is impossible, perform diagnosis according to “Diagnostic Procedure Used When Abnormal Communication with Subaru Select Monitor Occurs”. Diagnostic Procedure for Subaru Select Monitor Communication">
Read diagnostic trouble code (dtc) Operation
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)OPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle informa ...
Other materials:
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Turbine Speed SensorINSPECTION1. Set the ST between the TCM and bulkhead harness.ST 18460AA040CHECK BOARD2. Set the probe of oscilloscope to the check board connector.Connector & terminalNo. 12 (+) — No. 42 (−):(A)+ probe(B)− probe3 ...
SRS airbag system servicing
WARNING
When discarding an airbag module
or scrapping the entire vehicle
damaged by a collision, consult
your SUBARU dealer.
The SRS airbag has no userserviceable
parts. Do not use
electrical test equipment on any
circuit related to the SRS airbag
system. For required servicing o ...
Windshield wiper blade rubber
1) Metal support
1. Grasp the locked end of the blade
rubber assembly and pull it firmly until the
stoppers on the rubber are free of the
metal support.
1) Metal spines
2. If the new blade rubber is not provided
with two metal spines, remove the metal
spines from the old blade rubber ...
