Subaru Crosstrek Service Manual: Rear turn signal light bulb

Installation

LIGHTING SYSTEM > Rear Side Marker Light BulbINSTALLATIONInstall each part in the reverse order of removal.Tightening torque:Light assembly - rear combination: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb ...

Inspection

LIGHTING SYSTEM > Rear Turn Signal Light BulbINSPECTION1. Visually check the bulb for blow out.2. Check the bulb specification. General Description > SPECIFICATION">3. Replace the bulb ...

Other materials:

Inspection
CLUTCH SYSTEM > Clutch SwitchINSPECTION1. CLUTCH START SWITCH1. Perform the following inspections. If the clutch start switch does not operate normally, adjust the switch, and check it again. Clutch Switch > ADJUSTMENT">• Make sure that engine does not start with clutch pedal no ...

Dtc c1711 steering angle sensor
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1711 STEERING ANGLE SENSORDTC detecting condition:Defective steering angle sensorTrouble symptom:• ABS does not operate.• VDC does not operate.• Hill start assist does not ...

Removal
INTAKE (INDUCTION)(H4DO) > Air Cleaner ElementREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the air intake duct. Air Intake Duct > REMOVAL">3. Disconnect the connector (A) from the mass air flow and intake air temperature sensor, and remove the clip (B). ...