Subaru Crosstrek Service Manual: Installation

Install each part in the reverse order of removal.

Tightening torque:

Light assembly - rear combination: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)

Removal

Reflex reflector

Other materials:

Bulkhead wiring harness (in engine compartment) Location
WIRING SYSTEM > Bulkhead Wiring Harness (In Engine Compartment)LOCATIONConnectorConnecting toNo.PoleColorAreaNo.DescriptionB35BlackB-2 Mass air flow and intake air temperature sensorB62Light grayC-3 Front ABS wheel speed sensor RHB85Light grayB-5 Front wiper motorB104Light grayC-4 Pressure switch ...

Caution
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > General DescriptionCAUTION• Prior to starting work, pay special attention to the following:1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.2. Protect the vehicle using a s ...

Assembly
SEATS > Front SeatASSEMBLYCAUTION:• Do not confuse the harness routing of the side airbag harness and the seat belt inner - front harness, etc. Assembling with harnesses improperly routed may cause the harness to get caught and short out.• If the flat mat hook of the frame assembly - ...