Subaru Crosstrek Service Manual: Caution
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > General Description
CAUTION
• Prior to starting work, pay special attention to the following:
1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.
2. Protect the vehicle using a seat cover, fender cover, etc.
3. Prepare the service tools, clean cloth, containers to catch grease and oil, etc.
• Place “NO OPEN FLAMES” signs near the working area.
• Prepare a container and cloth to prevent scattering of fuels when performing work where fuels can be spilled. If the oil spills, wipe it off immediately to prevent from penetrating into floor or flowing out for environmental protection.
• Vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.
• When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement.
• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery.
• Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle.
• Remove contamination including dirt and corrosion before removal, installation, disassembly or assembly.
• Keep the removed parts in order and protect them from dust and dirt.
• All removed parts, if to be reused, should be reinstalled in the original positions with attention to the correct directions, etc.
• Bolts, nuts and washers should be replaced with new parts as required.
• Always inspect for fuel leaks after removing/installing the fuel system components.
• Follow all government and local regulations concerning disposal of refuse when disposing fuel.
• Always use new application oil during work.
Specification
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > General DescriptionSPECIFICATIONFuel tankCapacity60 L (15.9 US gal, 13.2 Imp gal)LocationUnder rear seatFuel pumpTypeImpellerShutoff discharge pressure750 kPa ...
Other materials:
Wiring diagram
SECURITY AND LOCKS > Push Button Start SystemWIRING DIAGRAMFor wiring diagrams related to the push button start system (ignition change), refer to the following items.• Keyless access system: Keyless Access System > WIRING DIAGRAM">• Push button start system: Push Button ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Crankshaft Position Sensor PlateREMOVALThe crankshaft position sensor plate is tightened together with the drive plate or flywheel; therefore, refer to “Drive Plate” or “Flywheel” for removal procedure. Drive Plate > REMOVAL"& ...
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > CompressorREMOVAL1. CROSSTREK MODEL1. Perform compressor oil return operation. Compressor Oil > PROCEDURE">2. Turn the A/C switch to OFF, and turn the ignition switch to OFF.3. Using the refrigerant recovery system, discharge refrigerant. Re ...
