Subaru Crosstrek Service Manual: Inspection
LIGHTING SYSTEM > Rear Turn Signal Light Bulb
INSPECTION
1. Visually check the bulb for blow out.
2. Check the bulb specification. General Description > SPECIFICATION">
3. Replace the bulb if it is found defective.
Removal
LIGHTING SYSTEM > Rear Turn Signal Light BulbREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful ...
Other materials:
After driving
Always check your brakes for effectiveness
immediately after driving in sand,
mud or water. Do this by driving slowly
and stepping on the brake pedal. Repeat
that process several times to dry out the
brake discs and brake pads.
After driving through tall grass, mud,
rocks, sand, riv ...
General diagnostic table Inspection
BODY CONTROL SYSTEM (DIAGNOSTICS) > General Diagnostic TableINSPECTIONRead the DTC using Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)"> Or check the following data under the current data display screen. Read Current Data">ItemOperationSpecificationsNoteYESNODiagnost ...
Assembly
MECHANICAL(H4DO) > Chain CoverASSEMBLY1. Install the camshaft position sensor. Camshaft Position Sensor > INSTALLATION">2. Install the oil control solenoid. Oil Control Solenoid > INSTALLATION">3. Install the engine oil temperature sensor. Engine Oil Temperature Sensor &g ...
