Subaru Crosstrek Service Manual: Wiring diagram
LIGHTING SYSTEM > Turn Signal Light and Hazard Light System
WIRING DIAGRAM
Refer to “Turn Signal Light and Hazard Light System” in the wiring diagram. Turn Signal Light and Hazard Light System > WIRING DIAGRAM">
Inspection
LIGHTING SYSTEM > Turn Signal Light and Hazard Light SystemINSPECTION1. CHECK TURN SIGNAL SWITCHRefer to the “INSPECTION” of the “Combination Switch (Light)”. Combination S ...
Note
LIGHTING SYSTEM > Turn Signal Light and Hazard Light SystemNOTEFor operation procedures of each component of the turn signal and hazard light system, refer to the respective sections.• Combin ...
Other materials:
Installation
DIFFERENTIALS > Rear Differential (T-type)INSTALLATION1. Attach the rear differential member plate to the rear differential.(A)Rear differential member plate2. Set the rear differential to transmission jack.3. Set the ST to the rear differential.ST 28099PA090OIL SEAL PROTECTOR4. Insert the rea ...
Specification
VEHICLE DYNAMICS CONTROL (VDC) > VDC Sequence ControlSPECIFICATION1. CONDITIONS FOR COMPLETION OF VDC SEQUENCE CONTROLWhen the following conditions develop, the VDC sequence control stops and VDC operation is returned to the normal control mode.• When the speed of at least one wheel reaches ...
Installation
COOLING(H4DO) > Water PumpINSTALLATION1. WATER PUMP PULLEY1. Using the ST, install the water pump pulley.ST1 18355AA000PULLEY WRENCHST2 18334AA030PULLEY WRENCH PIN SETTightening torque:14 N·m (1.4 kgf-m, 10.3 ft-lb)2. Install the under cover. Front Under Cover > INSTALLATION" ...
