Subaru Crosstrek Service Manual: Turn signal light and hazard light system

Installation

LIGHTING SYSTEM > Tail/Stop Light BulbINSTALLATIONInstall each part in the reverse order of removal.Tightening torque:Light assembly - rear combination: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb) ...

Inspection

LIGHTING SYSTEM > Turn Signal Light and Hazard Light SystemINSPECTION1. CHECK TURN SIGNAL SWITCHRefer to the “INSPECTION” of the “Combination Switch (Light)”. Combination S ...

Other materials:

Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Sunload Sensor (Auto A/C Model)REMOVALCAUTION:Be careful not to damage the sensors and interior trims when removing.1. Disconnect the ground cable from battery. NOTE">2. Remove the sunload sensor.(1) Release the connectors and claws, and then re ...

Adjustment
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission CaseADJUSTMENTNOTE:When replacing the transmission case with a new part, perform the following check and adjustment for the selection.• Select the transfer driven gear shim. Transfer Clutch > ADJUSTMENT">• Select the ...

Dtc u0073 control module communication bus off
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0073 CONTROL MODULE COMMUNICATION BUS OFFDetected when CAN line abnormality is detected.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE&q ...