Subaru Crosstrek Service Manual: Installation

CAUTION:

• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

• Do not allow harness and connectors to interfere or get tangled up with other parts.

• If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position.

• If the steering wheel and steering angle sensor (steering roll connector) are removed, perform the VDC setting mode. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

1. Align the center position of the steering roll connector. Roll Connector > ADJUSTMENT">

2. Install each part in the reverse order of removal.

NOTE:

Align the alignment marks on the steering wheel and the column assembly - steering.

Tightening torque:

Steering wheel: 39 N·m (3.98 kgf-m, 28.8 ft-lb)

Clearance:

Between cover assembly - column and steering wheel: 4 — 6 mm (0.16 — 0.24 in)

Removal

Day time running light system

Other materials:

Dtc p1497 coil 3 egr "a" control circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P1497 COIL 3 EGR "A" CONTROL CIRCUIT HIGHNOTE:For the diagnostic procedure, refer to DTC P1499. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P1499 COIL 4 EGR "A" CONTRO ...

Inspection
CLUTCH SYSTEM > Clutch FluidINSPECTIONCAUTION:Be careful not to spill the brake fluid. Brake fluid spilled on the vehicle body will harm the paint surface; wash it off with water and wipe clean quickly if spilled.1. Park the vehicle on a level surface.2. Check the brake fluid level using the scal ...

Installation
EXTERIOR/INTERIOR TRIM > Instrument Panel AssemblyINSTALLATIONCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• After installing the p ...