Subaru Crosstrek Service Manual: Removal
LIGHTING SYSTEM > Tail/Stop Light Bulb
REMOVAL
1. CROSSTREK MODEL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the light assembly - rear combination.
CAUTION:
Be careful not to damage the clips.
(1) Release the bolts and clips, then pull out the light assembly - rear combination to the vehicle rear.
(2) Disconnect the connector and remove the light assembly - rear combination.
3. Remove the bulb socket and tail light/stop light bulb.
CAUTION:
Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.
Inspection
LIGHTING SYSTEM > Tail/Stop Light BulbINSPECTION1. Visually check the bulb for blow out.2. Check the bulb specification. General Description > SPECIFICATION">3. Replace the bulb if it i ...
Installation
LIGHTING SYSTEM > Tail/Stop Light BulbINSTALLATIONInstall each part in the reverse order of removal.Tightening torque:Light assembly - rear combination: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb) ...
Other materials:
When checking or servicing in the engine compartment
CAUTION
Do not contact the drive belt
cover while checking the components
in the engine compartment.
Doing so may cause your
hand to slip off the cover and
result in an unexpected injury.
Do not touch the oil filter until the engine has cooled down
completely.
Doing so m ...
Removal
EXTERIOR/INTERIOR TRIM > Roof SpoilerREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate UPR. Rear Gate Trim > REMOVAL">3. Remove the roof spoiler assembly.(1) Disconnect the connector of high-mounted stop light.(2) Remove the caps, ...
Specification
LIGHTING SYSTEM > General DescriptionSPECIFICATIONNo.DescriptionCapacity and wattageType(1)HeadlightLow beam (halogen type)12 V — 55 WH11Low beam (HID type)12 V — 35 WD2RHigh beam12 V — 60 WHB3Front turn signal light12 V — 21 WWY21WParking light12 V — 5 WW5WSide marker light12 V — 5 W ...
