Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Radio

Usually, a problem with radio reception does not mean there is a problem with the radio - it is just the normal result of conditions outside the vehicle.

For example, nearby buildings and terrain can interfere with FM reception. Power lines or phone wires can interfere with AM signals. And of course, radio signals have a limited range. The farther the vehicle is from a station, the weaker its signal will be. In addition, reception conditions change constantly as the vehicle moves.

Here, some common reception problems that probably do not indicate a problem with the radio are described.

FM

Fading and drifting stations: Generally, the effective range of FM is about 25 miles (40 km). Once outside this range, you may notice fading and drifting, which increase with the distance from the radio transmitter.

They are often accompanied by distortion.

Multi-path: FM signals are reflective, making it possible for 2 signals to reach the vehicle's antenna at the same time. If this happens, the signals will cancel each other out, causing a momentary flutter or loss of reception.

Static and fluttering: These occur when signals are blocked by buildings, trees or other large objects. Increasing the bass level may reduce static and fluttering.

Station swapping: If the FM signal being listened to is interrupted or weakened, and there is another strong station nearby on the FM band, the radio may tune in the second station until the original signal can be picked up again.

AM

Fading: AM broadcasts are reflected by the upper atmosphere - especially at night. These reflected signals can interfere with those received directly from the radio station, causing the radio station to sound alternately strong and weak.

Station interference: When a reflected signal and a signal received directly from a radio station are very nearly the same frequency, they can interfere with each other, making it difficult to hear the broadcast.

Static: AM is easily affected by external sources of electrical noise, such as high tension power lines, lightening or electrical motors. This results in static.

SiriusXM (if equipped)

Tips for operating the audio/visual system
CAUTION To avoid damage to the audio/visual system: Be careful not to spill beverages over the audio/visual system. Do not put anything other than an appropriate disc into the disc slot. ...

CD player and disc
This CD player is intended for use with 4.7 in. (12 cm) discs only. Extremely high temperatures can keep the CD player from working. On hot days, use the air conditioning system to cool the ...

Other materials:

Before driving your vehicle
Before entering the vehicle, remove any snow or ice from your shoes because that could make the pedals slippery and driving dangerous. While warming up the vehicle before driving, check that the accelerator pedal, brake pedal, and all other controls operate smoothly. Clear away ice and sno ...

Rear wiring harness and rear gate cord Location
WIRING SYSTEM > Rear Wiring Harness and Rear Gate CordLOCATIONConnectorConnecting toNo.PoleColorAreaNo.DescriptionR163C-4 Rear door switch RHR223C-2 Rear door switch LHR2510BlackC-2 Radar sensor LH (master)R266GrayC-5 Rear combination light RHR286GrayC-3 Rear combination light LHR293BlackD-2 Rear ...

Assembly
CLUTCH SYSTEM > Clutch PedalASSEMBLY1. Install the stopper and pedal pad to the clutch pedal.2. Install the clutch switch to the pedal bracket.3. Clean the pedal bushing holes of the clutch pedal and the brake pedal, apply grease, and install the pedal bushings.4. Install the clutch pedal, brake ...

© 2016-2025 Copyright www.sucross.com