Subaru Crosstrek Owners Manual: Audio set
Your vehicle may be equipped with one of the following audio sets. Refer to the pages indicated in this section for operating details.
- CAUTION
- Always consult your SUBARU dealer before installing a citizen band radio or other transmitting device in your vehicle. Such devices may cause the electronic control system to malfunction if they are incorrectly installed or if they are not suited for the vehicle.
- To prevent the battery from being discharged, do not leave the audio/visual system on when the engine is not running.
NOTE
- If a cell phone is placed near the audio set, it may cause the audio set to emit noise when the phone receives calls. This noise does not indicate an audio set malfunction. Note that a cell phone should not be placed near the audio set.
- Some functions may not be available depending on the market and specifications of your vehicle.
- The images shown in this Owner's Manual are sample images. The actual images may vary depending on the market and specifications of your vehicle.
- Base display audio set (if equipped)
- STARLINKTM 7.0 Multimedia Plus audio set (U.S. spec. models only, if equipped)
- Tips for operating the audio/visual system
- Basic information before use
- Basic operation
- Unit settings
- SUBARU STARLINK (if equipped)
- AM/FM radio
- SiriusXM Satellite Radio (if equipped)
- ahaTM by HARMAN
- Pandora(if equipped)
- CD
- USB memory
- iPod
- Bluetooth audio
- AUX
Roof antenna (for Shark fin type)
The radio antenna, satellite radio antenna
and telematics antenna (if equipped) are
installed in the center of the roof at the
rear. ...
Base display audio set (if equipped)
Power/VOLUME knob
Eject button
AUDIO/TUNE knob
HOME button
APPS button
Display
SEEK/TRACK buttons
The audio set will operate only when the
ignition switch is in the "ACC" or "ON ...
Other materials:
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Coolant Temperature SensorINSPECTION1. Check that the engine coolant temperature sensor has no deformation, cracks or other damages.2. Immerse the engine coolant temperature sensor and a thermometer in water.CAUTION:Take care not to allow water to get ...
Daylight saving time setting
1. Perform the preparation steps according
to "Preparation for date setting" 3-
56.
2. Operate the "
" or "
"
switch to
select the "Daylight Saving Time" item.
Then push the
button.
3. The current setting will be displayed.
Push the
button to enter the selection ...
Removal
SECURITY AND LOCKS > Keyless Entry Control ModuleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear apron LH. Rear Quarter Trim > REMOVAL">3. Remove the keyless entry control module.(1) Disconnect the connector.(2) Remove the bolt and th ...
