Subaru Crosstrek Owners Manual: Basic operation
This section describes some of the basic features of the audio/visual system. Some information may not pertain to your system.
Your audio/visual system works when the ignition switch is turned to the "ACC" or "ON" position.
CAUTION
To prevent the battery from being discharged, do not leave the audio/ visual system on longer than necessary when the engine is not running.
NOTE
Some functions can also be operated by using the voice command system.
For details, refer to "Voice command system"
Connecting and disconnecting a USB memory/portable device
The USB port and the AUX jack are
located as shown in the following illustration.
NOTE
This unit does not support commercially
available USB hubs.
Turn on the power of the device
when ...
Turning the system on and off
Press the power/VOLUME knob to turn
the audio/visual system on and off. When
the system turns on, the mode that was in
use the last time the system was turned off
will be displayed. Press and ...
Other materials:
Basic procedures
WIRING SYSTEM > Basic Diagnostic ProcedureBASIC PROCEDURES1. GENERAL DESCRIPTIONThe most important purpose of diagnostics is to quickly determine which part is malfunctioning, to save time and labor.2. IDENTIFICATION OF TROUBLE SYMPTOMDetermine what the problem is based on the symptom.3. PROBABLE ...
Inspection
LIGHTING SYSTEM > Hazard SwitchINSPECTION1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard2 — 3Switch OFF1 M? or moreSwitch ONLess than 1 ?2. Apply battery voltage between the connector terminals to check the lighting ...
Adjustment
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Compressor OilADJUSTMENT• If a component has been replaced, add an appropriate amount of compressor oil (same as the amount of remaining oil in removed component).• When replacing the compressor assembly, the new compressor assembly will alre ...
