Subaru Crosstrek Service Manual: Dtc p0711 transmission fluid temperature sensor "a" circuit range/performance
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC P0711 TRANSMISSION FLUID TEMPERATURE SENSOR "A" CIRCUIT RANGE/PERFORMANCE
DTC DETECTING CONDITION:
Detected when two consecutive driving cycles with fault occur.
TROUBLE SYMPTOM:
• Excessive shift shock
• Shift characteristics malfunction
NOTE:
For the diagnostic procedure, perform the diagnosis according to DTC P0712 and P0713. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0712 TRANSMISSION FLUID TEMPERATURE SENSOR "A" CIRCUIT LOW">
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0713 TRANSMISSION FLUID TEMPERATURE SENSOR "A" CIRCUIT HIGH">
1. OUTLINE OF DIAGNOSIS
Diagnosis 1
• Detect the malfunction of the transmission oil temperature sensor characteristics (stuck to low temperature side).
• Judge as NG if the amount of oil temperature change since ignition ON is equal to or below the predetermined value.
Diagnosis 2
• Detect the malfunction of the transmission oil temperature sensor characteristics (stuck to high temperature side).
• Judge as NG when the difference between engine coolant temperature and CVT oil temperature is equal to or more than specified value at starting.
2. EXECUTION CONDITION
Secondary Parameters | Execution condition |
Diagnosis 1 | |
12 V battery system voltage | ≥ 10 V |
Engine speed (The timer is held when the following conditions are not satisfied.) | > 600 rpm |
Transmission range | Drive |
Vehicle speed (calculated from secondary pulley shaft speed) | ≥ 21.9 MPH |
Diagnosis 2 | |
12 V battery system voltage | ≥ 10 V |
Engine coolant temperature at the end of the previous drive cycle − Engine coolant temperature at engine start | ≥ 40 degC |
3. DIAGNOSTIC METHOD
If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.
Malfunction Criteria | Threshold Value |
Diagnosis 1 | |
Absolute change of measured Transmission fluid temperature sensor input voltage | ≤ 0.049 V |
Transmission fluid temperature | < 20 degC |
Diagnosis 2 | |
Transmission fluid temperature − Engine coolant temperature at engine start | > 46 degC |
Time Needed for Diagnosis:
• Diagnosis 1: 600 s
• Diagnosis 2: 300 s
Malfunction Indicator Light Illumination: Illuminates when malfunction occurs in 2 continuous driving cycles.
Dtc p0708 transmission range sensor "a" circuit high
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0708 TRANSMISSION RANGE SENSOR "A" CIRCUIT HIGHDTC detecting condition:Immed ...
Dtc p0712 transmission fluid temperature sensor "a" circuit low
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0712 TRANSMISSION FLUID TEMPERATURE SENSOR "A" CIRCUIT LOWDTC detecting cond ...
Other materials:
Dtc p1449 evap system clog detected (air filter)
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P1449 EVAP SYSTEM CLOG DETECTED (AIR FILTER)DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode C ...
Passenger's frontal airbag ON and OFF indicator lights
Front passenger's frontal airbag ON indicator light
Front passenger's frontal airbag OFF indicator light
Occupant detection system
Occupant detection sensors
The Subaru Ascent is equipped with an advanced occupant detection system designed
to enhance ...
Basic diagnostic procedure Procedure
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURESTEPCHECKYESNO1.PERFORM CUSTOMER INTERVIEW.Using the Check List for Interview, ask the customer the condition of how the trouble occurred. Check List for Interview > CHECK">Did you interview the cust ...
