Subaru Crosstrek Service Manual: Inspection

1. Install the light to check if it blinks normally.

2. If it fails to blink normally, replace the light assembly - side turn mirror with a new part.

NOTE:

Since LED (Light Emitting Diode) is used for the light, replace the light assembly - side turn mirror if the LED burns out.

Side turn signal light assembly

Removal

Other materials:

Specification
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > General DescriptionSPECIFICATION1. MANUAL TRANSMISSION AND DIFFERENTIALModelCrosstrek modelType5-forward speeds and 1-reverse (all stage with synchromesh)Transmission gear ratio1st3.5452nd1.8883rd1.2964th0.9725th0.780Rev.3.333Front reduction gearFinalTy ...

Removal
PARKING BRAKE > Parking Brake CableREMOVALCAUTION:• Refer to “CAUTION” of “General Description” before handling the airbag system components. General Description > CAUTION">• Airbag system satellite safing sensor is located in the lower of the rear ...

Dtc p0354 ignition coil "d" primary control circuit/open
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0354 IGNITION COIL "D" PRIMARY CONTROL CIRCUIT/OPENNOTE:For the diagnostic procedure, refer to DTC P0351. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0351 IGNITION COIL " ...