Subaru Crosstrek Service Manual: Removal
LIGHTING SYSTEM > Side Turn Signal Light Assembly
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the light assembly - side turn mirror. Outer Mirror Assembly > DISASSEMBLY">
Inspection
LIGHTING SYSTEM > Side Turn Signal Light AssemblyINSPECTION1. Install the light to check if it blinks normally.2. If it fails to blink normally, replace the light assembly - side turn mirror with a ...
Installation
LIGHTING SYSTEM > Side Turn Signal Light AssemblyINSTALLATIONInstall each part in the reverse order of removal. ...
Other materials:
Drain filter Specification
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Drain FilterSPECIFICATIONThe leak check valve assembly is a non-disassembled part. Do not remove the drain filter from the leak check valve assembly. Refer to “Leak Check Valve Assembly” for removal and installation procedures. ...
Removal
EXTERIOR/INTERIOR TRIM > Sun VisorREMOVAL1. Remove the sun visor assembly.(1) Remove the cap - sun visor, and then remove the screws.(2) Disconnect the connector and remove the sun visor assembly.2. Remove the hook - sun visor.(1) Press both sides using a flat tip screwdriver.(2) Remove the hook ...
Dtc p060a internal control module monitoring processor performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P060A INTERNAL CONTROL MODULE MONITORING PROCESSOR PERFORMANCENOTE:For the diagnostic procedure, refer to DTC P0606. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0606 CONTROL MODULE PROCE ...
