Subaru Crosstrek Service Manual: Removal
BRAKE > Stop Light Switch
REMOVAL
CAUTION:
Before handling the airbag system components, always refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL">
3. Remove the knee airbag module. Knee Airbag Module > REMOVAL">
4. Remove the stop light switch.
(1) Disconnect the stop light switch connector.
(2) Remove the stop light switch by turning it counterclockwise.
Adjustment
BRAKE > Stop Light SwitchADJUSTMENT1. BULB TYPECAUTION:• Turn the stop light switch clockwise when installing so that it can return backward by approximately 1 mm (0.04 in) and clearance is a ...
Inspection
BRAKE > Stop Light SwitchINSPECTION1. CLEARANCE CHECKNOTE:Check for clearance is applied only to LED model.1. Measure the clearance between the end of the stop light switch and the stopper.Specific ...
Other materials:
12
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code12Detected when brake pedal is depressed or malfunction related to stop light & brake switch occurs.TROUBLE SYMPTOM:• Cruise control cannot be set.• Cruise control cannot be released.WIRING DIAGRAM:Cruise c ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Drive Pinion Shaft AssemblyINSTALLATION1. Clean the mating surface of drive pinion retainer and converter case.2. Adjust the backlash and tooth contact between drive pinion shaft assembly and the front differential side gear. Drive Pinion Shaft Assembl ...
Driving on grades
Before going down a steep hill, slow
down and shift into lower gear (if necessary,
use 1st gear) in order to utilize the
engine braking effect and prevent overheating
of your vehicle's brakes. Do not
make sudden downshifts.
When driving uphill in hot weather, the
air conditioner may ...
