Subaru Crosstrek Service Manual: Assembly
WIPER AND WASHER SYSTEMS > Wiper Blade
ASSEMBLY
1. FRONT
1. Insert the rubber assembly - windshield wiper onto the blade - windshield wiper so that the stopper is in the position shown in the figure.
2. Make sure the rubber assembly - windshield wiper is securely fastened to the pull stopper (a).
2. REAR
1. Insert the rubber assembly - rear wiper into claw (B).
2. Insert the rubber assembly - rear wiper until its top end protrudes approx. 20 mm (0.79 in) from stopper (D).
3. Insert the rubber assembly - rear wiper into claw (A).
Wiper blade
...
Removal
WIPER AND WASHER SYSTEMS > Wiper BladeREMOVAL1. FRONTWhile pushing the locking clip (A) up, pull out the blade assembly - windshield wiper in the direction of the arrow, and remove it from the arm ...
Other materials:
Component
STARTING/CHARGING SYSTEMS(H4DO) > General DescriptionCOMPONENT1. STARTER(1)Starter housing ASSY(9)Overrunning clutch(17)Sleeve bearing(2)Sleeve bearing(10)Internal gear ASSY(18)Starter cover ASSY(3)Shift lever(11)Shaft (4)Plate(12)Pinion gearTightening torque: N·m (kgf-m, ft-lb)(5)Seal rub ...
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Expansion ValveREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Using the refrigerant recovery system, discharge refrigerant. Refrigerant Recovery Procedure > PROCEDURE">3. Remove the air intake boot. Air Intake Boot > ...
Monitor (if equipped)
To clean the audio/navigation/multi function
display monitor, wipe it with a silicone
cloth or with a soft cloth. If the monitor is
extremely dirty, clean it with a soft cloth
moistened with neutral detergent then
carefully wipe off any remaining detergent.
CAUTION
Do not spray neutral det ...
