LIGHTING SYSTEM > Rear Combination Light Assembly
INSTALLATION
Install each part in the reverse order of removal.
Tightening torque:
Light assembly - rear combination: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
Inspection
SECURITY AND LOCKS > Push Button Ignition SwitchINSPECTION1. Check the continuity between push button ignition switch terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsSpecification4 (COM) — 5 (GND)AlwaysContinuity exists7 (SSW1) — 5 (GND)Push button ignition switch re ...
Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Front Differential AssemblyADJUSTMENT1. DIFFERENTIAL BEVEL PINION GEAR BACKLASH1. Disassemble the front differential assembly. Front Differential Assembly > DISASSEMBLY">2. Select the adjusting washer from the table and install.Adjusting was ...
Radar sensor
Adjustment
Blind Spot Detection/Rear Cross Traffic Alert > Radar SensorADJUSTMENT1. RADAR AXIS ADJUSTMENTCAUTION:• After removal/installation or replacement of the radar sensor, perform the radar axis adjustment.• The procedure for the master is only shown here. However the procedure ...