Subaru Crosstrek Service Manual: Rear height sensor

Installation

LIGHTING SYSTEM > Rear Combination Light AssemblyINSTALLATIONInstall each part in the reverse order of removal.Tightening torque:Light assembly - rear combination: 7.5 N·m (0.76 kgf-m, 5.5 f ...

Inspection

LIGHTING SYSTEM > Rear Height SensorINSPECTION1. Connect three dry cell batteries (1.5 V) in series.NOTE:• Use new dry-cell batteries.• Using a circuit tester, check that the initial vo ...

Other materials:

Models with "keyless access with push-button start system"
NOTE For more details, refer to the Owner's Manual supplement for the remote engine start system. Access key Lock button An access key can be used as the remote engine start transmitter. Operate the lock button to start or stop the engine as follows. Before starting the engine Befo ...

Disabling keyless access function
WARNING If you use an implanted pacemaker or defibrillator, it is strongly recommended to disable the Subaru Ascent keyless access function by following the procedure described in the section "By operating the driver's door". Avoid disabling the system via the access key fob, as ...

Installation
EXTERIOR BODY PANELS > Front DoorINSTALLATION1. FRONT DOOR PANEL1. Put a wooden block on a jack and place the panel assembly - front door on it.2. Apply grease to the sliding area of door hinges, and install the door hinge to vehicle.3. Adjust the height by the jack, and temporarily install the p ...