Subaru Crosstrek Service Manual: Installation
LIGHTING SYSTEM > Rear Height Sensor
INSTALLATION
1. Install each part in the reverse order of removal.
Tightening torque:
Sensor assembly - headlight beam leveler: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
Rear wheel: Except for C4 model
120 N·m (12.24 kgf-m, 88.5 ft-lb)
Rear wheel: C4 model
100 N·m (10.20 kgf-m, 73.8 ft-lb)
2. Perform reinitialization of the sensor assembly - headlight beam leveler. Auto Headlight Beam Leveler System > PROCEDURE">
NOTE:
When replacing the sensor assembly - headlight beam leveler with a new part, perform the initialization. Auto Headlight Beam Leveler System > PROCEDURE">
Removal
LIGHTING SYSTEM > Rear Height SensorREMOVALCAUTION:Always remove the sensor assembly - headlight beam leveler before removing any parts related to the suspension.1. Disconnect the ground cable from ...
Other materials:
Installation
DRIVE SHAFT SYSTEM > Rear AxleINSTALLATION1. Temporarily tighten the rear axle housing to the upper arm assembly.2. Install the rear drive shaft assembly.CAUTION:• Do not hammer the drive shaft assembly when installing.• Use new axle nuts.(1) Insert the drive shaft assembly into the h ...
Dtc u0101 lost communication with tcm
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0101 LOST COMMUNICATION WITH TCMDetected when CAN data from TCM is not transmitted to stereo camera.When lost communication with TCM and TCM abnormal occur simultaneously, perform diagnosis for lost communication ...
Welcome lighting function (if
equipped)
The welcome lighting function turns on the
low beam headlight for smooth approaching
to or exiting from the vehicle at night or
in a dark place.
The function is activated while all of the
following conditions are met.
The light control switch is in the
"AUTO" position
It is dark enoug ...
