Subaru Crosstrek Service Manual: Inspection
DRIVE SHAFT SYSTEM > Front Drive Shaft
INSPECTION
Check the removed parts for damage, wear, corrosion etc. If faulty, repair or replace.
• PTJ (pillow tripod joint)
Check for seizure, corrosion, damage, wear and excessive play.
• EBJ (high-efficiency compact ball fixed joint)
Check for seizure, corrosion, damage and excessive play.
• Shaft:
Check for excessive bending, twisting, damage and wear.
• Boot:
Check for wear, warping, breakage and scratches.
• Grease:
Check for discoloration and fluidity.
Disassembly
DRIVE SHAFT SYSTEM > Front Drive ShaftDISASSEMBLY1. Place alignment marks on the shaft and outer race (PTJ).2. Remove the boot band and boot (PTJ).CAUTION:Be careful not to damage the boot.3. Remov ...
Installation
DRIVE SHAFT SYSTEM > Front Drive ShaftINSTALLATION1. Before installation, check the drive shaft assembly. Front Drive Shaft > INSPECTION">2. Replace the differential side retainer oil s ...
Other materials:
Basic diagnostic procedure Procedure
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:Remove foreign matter (dust, water, oil etc.) from the VDCCM&H/U connector during removal and installation.NOTE:• To check the harness for open or short circuits, shake problem spot or connector.&b ...
Installation
BRAKE > Front Disc Brake AssemblyINSTALLATIONNOTE:Before installation, remove mud and foreign matter from the caliper body assembly and support - front disc brake.1. Check each part. Front Disc Brake Assembly > INSPECTION">2. Apply a thin coat of grease to the support - front disc bra ...
Malfunction indicator light does not blink
ENGINE (DIAGNOSTICS)(H4DO) > Malfunction Indicator LightMALFUNCTION INDICATOR LIGHT DOES NOT BLINKDIAGNOSIS:• The malfunction indicator light circuit is open or shorted.• The delivery (test) mode fuse circuit is open.TROUBLE SYMPTOM:Malfunction indicator light does not blink during In ...
