Subaru Crosstrek Service Manual: Dtc c0041 parameter selection error

DTC DETECTING CONDITION:

VDCCM parameter selection error

TROUBLE SYMPTOM:

• ABS does not operate.

• EBD does not operate.

• VDC does not operate.

• EyeSight does not operate.

When the VDCCM&H/U is replaced, this DTC may be stored.

1.CHECK VDCCM&H/U IDENTIFICATION SYMBOL.

Check the identification symbol attached on the H/U. General Description > SPECIFICATION">

Is the identification symbol correct?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0041 PARAMETER SELECTION ERROR">Go to Step 2.

Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)">

2.CHECK PARAMETER SELECTED IN VDCCM.

Subaru Select Monitor > OPERATION">

Does the parameter registered in the VDCCM match the relevant vehicle?

Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)">

Select and register the correct parameter. Subaru Select Monitor > OPERATION">

Dtc c0041 ecm

Dtc c0042 power supply voltage failure

Other materials:

Inspection
LUBRICATION(H4DO) > Oil Level SwitchINSPECTION1. INSPECTION WHEN LOW ENGINE OIL WARNING LIGHT IS ILLUMINATEDSTEPCHECKYESNO1.CHECK ENGINE OIL LEVEL.Is engine oil level normal? Oil Level Switch > INSPECTION">Go to Step 2.Replace engine oil or refill, and check again while the oil level i ...

Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Sub Level SensorREMOVALWARNING:Place “NO OPEN FLAMES” signs near the working area.CAUTION:• Be careful not to spill fuel.• Catch the fuel from the tubes using a container or cloth.• If the fuel gauge indicates that two third ...

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Oil Pump ChainINSTALLATION1. Clean the mating surface of oil pump chain cover and converter case.2. Using the ST, install the oil seal.NOTE:• Use a new oil seal.• Apply CVTF to the oil seal lip and press-fitting surface.ST 499755602PRESS ...