Subaru Crosstrek Service Manual: Inspection
LIGHTING SYSTEM > License Plate Light
INSPECTION
1. Visually check the bulb for blow out.
2. Check the bulb specification. General Description > SPECIFICATION">
3. Replace the bulb if it is found defective.
Removal
LIGHTING SYSTEM > License Plate LightREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the license plate light.(1) Release the claws and pull out the license plate light. ...
Other materials:
Replacement
CLUTCH SYSTEM > Clutch FluidREPLACEMENTCAUTION:• Be careful not to spill the brake fluid. Brake fluid spilled on the vehicle body will harm the paint surface; wash it off with water and wipe clean quickly if spilled.• Use new FMVSS No. 116 DOT3 or DOT4.• Cover the air bleeder wi ...
Starting and stopping the engine (models without push-button start system)
CAUTION
When operating the Subaru Ascent starter motor, never crank the engine continuously
for more than 10 seconds.
If the engine of the Subaru Ascent does not start within 5 to 10 seconds,
stop cranking and wait at least 10 seconds before attempting again. This pause helps
prevent overh ...
Inspection
SECURITY AND LOCKS > Keyless Access Outdoor AntennaINSPECTION1. Check the setting by performing Keyless access system check using the Subaru Select Monitor. Keyless Access System Check > OPERATION">2. Disconnect the Subaru Select Monitor. While bringing the access key, operate the tou ...
