Subaru Crosstrek Service Manual: Note
EyeSight > Switches and Harness
NOTE
1. PRE-COLLISION BRAKE OFF SWITCH & LANE DEPARTURE WARNING OFF SWITCH
The pre-collision brake OFF & lane departure warning OFF switch is integrated in the stereo camera cover assembly.
If the pre-collision brake OFF & lane departure warning OFF switch is faulty, replace the stereo camera cover assembly. Stereo Camera">
2. EyeSight STEERING SWITCH
For the operation procedures for the EyeSight steering switch, refer to “CRUISE CONTROL SYSTEM” section. Cruise Control Command Switch">
Inspection
EyeSight > Switches and HarnessINSPECTION1. PRE-COLLISION BRAKE OFF SWITCH AND LANE DEPARTURE WARNING OFF SWITCH1. Measure the resistance between connector terminals.Preparation tool:Circuit tester ...
Body integrated unit Note
EyeSight > Body Integrated UnitNOTEFor the operation procedures for body integrated unit, refer to “STARTING/CHARGING SYSTEMS” section. Body Integrated Unit"> ...
Other materials:
Head restraint height adjustment
Head restraint
Release button
To raise:
Pull the head restraint up.
To lower:
Push the head restraint down while
pressing the release button on the top of
the seatback.
To remove:
While pressing the release button, pull out
the head restraint.
To install:
Install the head ...
Basic inspection
WIRING SYSTEM > Basic Diagnostic ProcedureBASIC INSPECTION1. VOLTAGE MEASUREMENT1. Using a voltmeter, connect the negative lead to a good ground point or negative battery terminal and the positive lead to the connector or component terminal.2. Contact the positive lead of the voltmeter on connect ...
Inspection
SECURITY AND LOCKS > Ignition Key LockINSPECTIONPreparation tool:Circuit tester1. Check the resistance between switch terminals.Terminal No.Inspection conditionsStandardBetween all terminals(A)LOCK1 M? or more2 — 4(B)ACCLess than 1 ?1 — 2 — 45 — 6(C)ONLess than 1 ?1 — 3 — 45 — 6 — ...
