Subaru Crosstrek Service Manual: Inspection
TELEMATICS SYSTEM (DIAGNOSTICS) > General Description
INSPECTION
1. BASIC INSPECTION
Before performing the diagnosis, check the following items which may affect the problems relating to the telematics system.
1. Check the battery. Battery">
2. Check the relay and fuse condition. Relay and Fuse">
3. Check the connecting condition of harness and harness connector.
Preparation tool
TELEMATICS SYSTEM (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubl ...
Other materials:
Inspection
COOLING(H4DO) > Engine CoolantINSPECTIONNOTE:When adding the engine coolant, always use SUBARU Super Coolant.1. Park the vehicle on a level surface.2. Turn the ignition switch to OFF.3. Check the engine coolant amount, and if the coolant level is low, check for the coolant leakage, and then add t ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Crankshaft Position SensorREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.3. Remove the air intake boot from the air cleaner case (rear) and throttle body, and move the ...
Dtc p2747 intermediate shaft speed sensor "b" circuit no signal
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2747 INTERMEDIATE SHAFT SPEED SENSOR "B" CIRCUIT NO SIGNALDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Standing start problems• Shock o ...
