Subaru Crosstrek Service Manual: Assembly

1. Install the oil drain plug.

Tightening torque:

70 N·m (7.1 kgf-m, 51.6 ft-lb)

2. Install the overflow drain plug.

NOTE:

Overflow plug of differential gear oil is temporarily attached.

3. Install all plugs.

NOTE:

Use new O-rings.

Tightening torque:

T1: 22 N·m (2.2 kgf-m, 16.2 ft-lb)

T2: 22.5 N·m (2.3 kgf-m, 16.6 ft-lb)

4. Install the pitching stopper bracket and transmission radio ground cord.

CAUTION:

Be careful not to deform or damage the terminal of transmission radio ground cord.

Tightening torque:

41 N·m (4.2 kgf-m, 30.2 ft-lb)

Converter case

Removal

Other materials:

Top display setting
1. Perform the preparation steps according to "Preparation for screen settings" 2. Operate the " " or " " switch to select the "Top Display" item. Then push the button. 3. Push the button once more. 4. Select an item by operating the "  " or "  " switc ...

Drive cycle Procedure
ENGINE (DIAGNOSTICS)(H4DO) > Drive CyclePROCEDUREIt is necessary to perform the drive cycle listed below if DTC is not found in the Inspection Mode. It is possible to complete diagnosis of the DTC by performing the indicated drive cycle. After the repair for the DTC, perform a necessary drive cyc ...

Adjustment
PARKING BRAKE > Parking Brake Assembly (Rear Disc Brake)ADJUSTMENT1. SHOE CLEARANCE1. Return the lever assembly - hand brake completely.2. Loosen the adjusting nut, and make the cable free.3. Remove the adjusting hole cover (A) from the rear disc rotor.4. Insert a flat tip screwdriver (b) into th ...