Subaru Crosstrek Service Manual: Assembly
LIGHTING SYSTEM > Headlight Assembly
ASSEMBLY
1. HID HEADLIGHT BALLAST
CAUTION:
• When installing the ballast - headlight, be sure to install the gasket.
• After installing the ballast to the vehicle, be sure to perform beam adjustment.
Assemble each part in the reverse order of disassembly.
Removal
LIGHTING SYSTEM > Headlight AssemblyREMOVALCAUTION:• Do not perform work with wet hands, because there is a possibility of electrical shock.• The HID type uses very high voltages for th ...
Disassembly
LIGHTING SYSTEM > Headlight AssemblyDISASSEMBLY1. HID HEADLIGHT BALLASTCAUTION:Do not leave the light assembly - head without the ballast - headlight for a long time. Dust, moisture, etc. entering ...
Other materials:
Dtc b1862 short in driver s knee airbag (to ground)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1862 SHORT IN DRIVER’S KNEE AIRBAG (TO GROUND)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Airbag main harness circuit is shorted to ground.• Knee airbag module harness c ...
Dtc p0113 intake air temperature sensor 1 circuit high bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0113 INTAKE AIR TEMPERATURE SENSOR 1 CIRCUIT HIGH BANK 1DTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Poor driving performanceCAUTION:After servicing o ...
New vehicle break-in driving - the first 1,000 miles (1,600 km)
The performance and long life of your
vehicle are dependent on how you handle
and care for your vehicle while it is new.
Follow these instructions during the first
1,000 miles (1,600 km):
Do not race the engine. And do not
allow engine speed to exceed 4,000 rpm
except in an emergency
...
