Subaru Crosstrek Service Manual: Disassembly
LIGHTING SYSTEM > Headlight Assembly
DISASSEMBLY
1. HID HEADLIGHT BALLAST
CAUTION:
Do not leave the light assembly - head without the ballast - headlight for a long time. Dust, moisture, etc. entering the light assembly - head may affect its performance.
1. Remove the cover - headlight.
2. Disconnect the bulb socket.
3. Remove the ballast - headlight.
(1) Disconnect the connector.
(2) Remove the screws and remove the ballast - headlight.
(3) Guiding the bulb socket through the gap between housing and reflector, pull out the ballast - headlight.
Assembly
LIGHTING SYSTEM > Headlight AssemblyASSEMBLY1. HID HEADLIGHT BALLASTCAUTION:• When installing the ballast - headlight, be sure to install the gasket.• After installing the ballast to th ...
Installation
LIGHTING SYSTEM > Headlight AssemblyINSTALLATIONCAUTION:Install so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes o ...
Other materials:
Drain filter Specification
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Drain FilterSPECIFICATIONThe leak check valve assembly is a non-disassembled part. Do not remove the drain filter from the leak check valve assembly. Refer to “Leak Check Valve Assembly” for removal and installation procedures. ...
Removal
FRONT SUSPENSION > Front StrutREMOVAL1. Lift up the vehicle, and then remove the front wheels.2. Remove the front strut assembly.(1) Place an alignment mark (a) on the adjusting bolt and the strut.(2) Remove the brake hose bracket.(3) Remove the clamp of ABS wheel speed sensor harness.(4) Remove ...
Installation
CLUTCH SYSTEM > FlywheelINSTALLATION1. Press in a new pilot bearing to the position where it is flush with the flywheel surface or up to 0.4 mm (0.016 in) deeper than that.CAUTION:Do not press the bearing inner ring.(A)Pilot bearing2. Temporarily tighten the crankshaft position sensor plate and f ...
